When you've located a target and dug the hole, use the Bullseye II Pinpointer to precisely "pinpoint" the target. No tuning. Completely automatic. Works in either "vibration" or "beep" mode. Powerful LED light illuminates target areas when the button is pushed. Powered for up to 20 hours on a single 9-Volt battery.

New! Treasure Hunting Database CD-ROM. Record your finds, locations, and detector settings in one program. Customize the screens for your detector. Search by location, type of find, and more. Organize and tally your treasures. Easy install. For Windows '98 and higher.
P/N 601-1214

Converts handheld Surfmasters to short rod for scuba use.
P/N 802-5195-1

Detector Stand DFX, XLT, MXT, QXT, Classic. Keeps detector off abrasive ground and wet grass.
P/N 502-0028

Plastic strips have common coins, trash targets, and a mineral sample attached for easy bench testing.
P/N 601-1130

Light blue plastic gold pan allows easy view of black sands and gold. Large 15" size with 3 layer built in ripples on one-third of pan edge.
P/N 601-0151-1

Converts Classics and early Goldmaster models from the standard two-piece rod assembly to a three-section assembly for tighter packing. (Does not fit Classic SL series instruments.)
P/N 802-5236

Handheld steel sand scoop. Dayglow yellow. Powder coated finish over galvanized steel.
P/N 601-0045-11

8" steel shaft with brazed ball bearing tip. 4" wire wrapped wood handle.
P/N 601-1128-1

Dayglow yellow rubber handle. Six and one-half inch stainless steel blade with inches labeled.
P/N 601-1145-1

White canvas material with White's logo and separate trash and treasure pouches.
P/N 601-0024

Detector cover. Resistant to water and dirt. Fits XLT and Quantums. (one piece)
P/N 601-1155

Fits all Classic SL's, Quantums and XLT. Mounts to existing control box screws. Keeps control box off abrasive ground.
P/N 802-5260

No extension cable. Hipmounts any SL model. Uses separate SL rod. Stainless steel bracket mounts on control box and allows the angle of the control box to be tilted for optimum display viewing.
P/N 802-5259

Extends loop cable length by approximately 5'. Replacement extension for hipmount kits manufactured from 1979 through 1988.
P/N 802-7022

Replacement "O" ring seal for main control box lid.
P/N 527-0043

Protects speaker from dirt and moisture.
P/N 624-0264

Rugged but comfortable design. Easy to put on and take off.
P/N 602-1113

Protects the Bullseye from mud and moisture. Conveniently clips on to your belt or pocket. Pouch stays on unit continuously during use.
P/N 601-1185

Replacement absorbent silica draws moisture away from internal components.
P/N 627-0045

Separate pouches for trash, treasure, and additional digging tools.(Belt not included)
P/N 601-0066

Ultimate trowel. Heat tempered, serrated edge. Sheath included.
P/N 601-0067